KNOW YOUR UNIT

Indexing Ring

Adjustment Bolt

Drive Shaft

Assembly

Angle

Adjustment

Handle

Blade

WARNING: DO NOT USE an extension boom with this product. It is not designed to be used with an extension and using one may cause serious injury.

ASSEMBLY INSTRUCTIONS

ASSEMBLING THE COUPLER

WARNING: Read and understand operator’s manual for unit to be used with this add-on prior to operation.

WARNING: To avoid serious personal injury and damage to the unit, shut unit off before removing or installing add-ons.

Installing the add-on:

NOTE: To make installing or removing the add-on easier, place the unit on the ground or on a work bench.

1.Remove the hanger from the top of the shaft housing.

2.Turn knob counterclockwise to loosen (Fig. 1).

Coupler

Release Button

 

Primary Hole

Upper Shaft

Lower Shaft

Housing

Housing

 

Knob

 

Fig. 2

90˚ Edge

Trimming Hole

Tighten

Loosen

Knob

Coupler

Guide Recess

Release Button

Knob

Fig. 3

Fig. 1

3.While firmly holding the add-on, push it straight into the coupler (Fig. 2).

NOTE: Aligning the release button with the guide recess will help installation (Fig. 3).

CAUTION: Lock the release button in the primary hole (Fig. 2) and securely tighten the knob before operating this unit.

4.Turn the knob clockwise to tighten (Fig. 1).

The hedge trimmer add-on should be installed with the release button in the primary hole.

CAUTION: The add-ons with the coupler system are to be used in the primary hole only. Using the wrong hole could lead to personal injury or damage to the unit.

4