MAINTENANCE AND REPAIR INSTRUCTIONS

2.Pull out the bump knob, spring, and foam seal (Fig. 14).

3.Pull the inner reel with existing line from the outer spool (Fig. 14).

4.Remove any existing line from the inner reel before cleaning. Remove any debris or grass from the knob, spring, inner reel, and foam seal. Wash the inner reel with warm soapy water (Fig. 17).

Inner Reel

Fig. 17

5.Clean the shaft and the inner surface of the outer spool. To clean the shaft underneath the plunger, press down on the plunger (Fig. 18). Remove any dirt or debris from the shaft.

NOTE: The inner reel must be totally dry before reinstalling it into the outer spool. Do not lubricate the inner reel or outer spool assembly.

6.Place the inner reel into the outer spool.

7.Place the bump knob, spring, and foam seal into the inner reel (Fig. 14).

8.Press the bump knob down and tighten clockwise.

9.Install new line as described in Line Installation for the SpeedSpool®

Shaft

Plunger

Fig. 18

SPEEDSPOOL® REPLACEMENT PARTS

Replacement Line . . . . . . . . . . . . . . . . . . . . . . . . 181472 Replacement Line Cartridge . . . . . . . . . . . . . . . . 181460 Inner Reel Spring . . . . . . . . . . . . . . . . . . . . . . . . 181465 Foam Seal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 181467 Inner Reel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 181464 Bump Head™ Assembly . . . . . . . . . . . . . . . . . . . 181468 (Bump Knob, Inner Reel, Spring, )

These SpeedSpool® replacement parts can be purchased from your local authorized dealer.

CLEANING

Use a small brush to clean off the outside of the unit. Do not use strong detergents. Household cleaners that contain aromatic oils such as pine and lemon, and solvents such as kerosene, can damage plastic housing or handle. Wipe off any moisture with a soft cloth.

STORAGE

•Check unit before storage to be sure the equipment is in safe working condition.

•Stop the engine or motor.

•Store the unit indoors, in a dry and locked place, out of the reach of children.

•Maintain or replace safety and instruction labels, as necessary.

For gas powerhead units

•Allow the unit to cool before storing in any enclosure.

•Drain fuel from unit. Never store the unit with fuel in the fuel tank inside a building where ignition sources are present such as hot water and space heaters, clothes dryers, etc.

TRANSPORTING

•Allow the unit to cool before transporting.

•Secure the unit while transporting.

For gas powerhead units

•Drain fuel from unit.

•Tighten fuel cap before transporting.

11