True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
ELECTRICAL INSTRUCTIONS
Step 4
A.Before your new unit is connected to a power supply, check the incoming voltage with a voltmeter. If anything less than 100% of the rated voltage for operation is noted, correct immediately.
B.All units are equipped with a 6 ft. (2.74m) service cord, and must be powered at proper operating voltage at all times. Refer to cabinet data plate for this voltage.
True requires that a sole use circuit be dedicated for the unit. Failure to do so voids warranty.
WARNING
Compressor warranties are void if compressor burns out due to low voltage.
WARNING
Power supply cord ground should not be removed!
NOTE
To reference wiring diagram - Remove front louvered grill, wiring diagram is positioned on the inside cabinet wall.
NOTE:
When loading product do not exceed product
load line labeled on the interior wall
of unit. (see photo)
MANUAL DEFROST
The unit will need to be manually defrosted. Unplug
unit until all frost is gone. The manual defrost
frequency will depend on the units usage, environment,
and the amount of frost.
If ice builds up on interior walls-
A.Remove product, unplug and roll unit so defrost plug is above floor drain (or large flat pan).
B.Remove plug and allow ice to melt and drain. Do not scrape interior of cabinet to loosen ice, as this will damage the cabinet. Allow cabinet to defrost with power off.
C.When ice has melted wipe up and water left in the freezer floor.
D.Be sure to replace defrost plug before moving freezer back in position.
E.Allow freezer to refrigerate and cycle before placing wire baskets and product back into freezer.
Photo
STARTUP
Step 5
A.The compressor is ready to operate. Plug in the Freezer.
B.Check the temperature control setting on the upper right of the compressor grill. The setting should be at #5.
RECOMMENDATION
Before loading product we recommend you run your True unit empty for two to three days. This allows you to be sure electrical wiring and installation are correct and no shipping damage has occurred. Remember, our factory warranty does not cover product loss!
NOTE
If the freezer is disconnected or shut off, wait five minutes before starting again.
NOTE
Excessive tampering with the control is not recommended as this can lead to service difficulties. Should it ever become necessary to order a replacement temperature control, be sure it is ordered from a dealer or recommended parts stocking service company.
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number for your freezer. If at any time during the life of your freezer, a part is needed, you may obtain this part by furnishing the model number and serial number to the company from whom you purchased the freezer. Call
7 | www.truemfg.com | 7 |
