Turbosound TSB-110 quick start Technical Specifications

quick start

TSB-110

Locate the four jumper locations on the circuit board, labelled J1, J2, J3, and J4. The unit is shipped with J2 and J4 connected with J1 and J3 not connected (dual 4 ohm mode). For single 8 ohm operation unplug J2 and J4 and transfer the jumpers to J1 and J3. This connects the two voice coils in series and transfers the input to the left input only (pins 1+ and 1- on the Speakon NL4MP). Note: In single coil mode DO NOT use the right inputs and outputs as this will result in incorrect operation and may damage loudspeakers and amplifiers.

TSB-110 Configured for 8 ohms TSB-110 Configured for 2 x 4 ohms

J1	J3	J1	J3
J2	J4	J2	J4

Technical Specifications

Dimensions	330mm x 585mm x 330mm (13” x 23” x 13”)
Net weight	16.5 kg (36.3 lbs)
Frequency Response	45Hz to 180Hz
Power Handling	300 watts r.m.s., 600 watts program
Nominal Impedance	2 x 4 ohms
Sensitivity	95dB, 1 watt @ 1metre
Calc. Max SPL	120dB continuous, 126dB peak
Crossover	Built-in high pass crossover network at 150Hz
Construction	15mm (5/8”) birch plywood
Rigging	4 x M10 internal rigging points
Options	TurboBlue or white semi-matt textured paint
Spares & Accessories	LS-1019.2	10” LF driver (requires M5 x 35 fixing bolts)
	RC-1019.2	recone kit

TSB-110 quick start guide

Page 3