Installation Manual P700WLS ioProx Receiver
DN1628-0806 7
Testing the Receivers
PCB LED Indicators
All LEDs are located on the PC board, inside the box.
Figure 3 LEDs Location
Y4: Flashes if the transmitter encryption code does not match the receiver configuration, and
will not operate the receiver. Check that the transmitters are programmed to operate with
this receiver.
Y5: Flashes when the transmitter code is valid.
Y6: RF activity indicator. The LED will flicker to indicate the receiver has power. If the LED
remains on steady, there is a continuous 433 MHz signal that will prevent the unit from
operating reliably.
Y8: Flashes when the Wiegand information is sent.
Y9: Controlled externally by the access control panel. Typically this is controlled by the access
control panels LED confirmation output (Brown wire). The Y9 LED is located on the PC
board, inside the box.
Y10 Power indicator.
LED Location