16 Port Ethernet Switch With Optional Fiber Port
Completing The Installation
When the switch has been installed as specified above, then the unit can be configured as detailed below:-
1.Apply AC power to the switch. The green Power LED on the front panel should light.
2.Connect the Cat. 5/5e twisted pair cables from the network partner devices to the
3.If the fiber uplink is not used, then connect the
4.If the fiber uplink is used, then connect the fiber link to the partner device (media converter, fiber NIC card or fiber switch etc). Ensure that the fiber uplink is set in the correct duplex mode (default = Full Duplex) using the front panel switch on the module. Verify that the green Link LED on the fiber module is lit which indicates that the optical link is valid.
5.If advanced modes such as port trunking or
6.If there are legacy devices that do not support
7.Note that
| Tyco Electronics | Page 5 |
|