Tyco Electronics 1739L R

REGULATORY INFORMATION

A) Compliance is required with respect to the voltage, frequency, and current requirements

indicated on the manufacturer’s label. Connection to a different power source than those

specified herein will likely result in improper operation, damage to the equipment or pose a fire

hazard if the limitations are not followed.

B) There are no operator serviceable parts inside this equipment. There are hazardous voltages

generated by this equipment which constitute a safety hazard. Service should be provided only

by a qualified service technician.

C) This equipment is provided with a detachable power cord which has an integral safety ground

wire intended for connection to a grounded safety outlet.

1) Do not substitute the cord with other than the provided approved type. Under no

circumstances use an a d a pter plug to connect to a 2-wire outlet a s this will def eat the

continuity of the grounding wire.

2) The equipment requires the use of the ground wire as a part of the safety certification,

modification or misuse can provide a shock hazard that can result in serious injury or

death.

3) Contact a qualified electrician or the ma nufacturer if there are questions about the

installation prior to connecting the equipment to mains power.

A) Notice to Users in the United States: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy, and if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications.

B) Notice to Users in Canada: This equipment complies with the Class B limits for radio noise

emissions from digital apparatus as established by the Radio Interf erence Regulations of Industrie

Canada.

C) Notice to Users in the European Union: Use only the provided power cords and

interconnecting cabling provided with the equipment. Substitution of provided cords and cabling

may compromise electrical safety or CE Mark Certification for emissions or immunity as

required by the following standards: