Tyco Electronics M7200 - page 9

MM23016

2.2.1 Mobile Antennas

Install the radio’s antenna (refer to Table 2-1 for applicable antenna part numbers) in the center of the

vehicle’s roof. These mobile antenna installation guidelines are limited to metal body motor vehicles or

vehicles with appropriate ground planes. The antenna installation should additionally be in accordance

with the following.

1. The requirements of the antenna manufacturer/supplier included with the antenna.

2. Instructions in the M7200 Radio Installation Manual, including minimum antenna cable lengths.

3. The installation manual providing specific information of how to install the antennas to facilitate

recommended operating distances to all potentially exposed persons.

Use only the M/A-COM approved/supplied antenna(s) or approved replacement antenna. Unauthorized

antennas, modifications, or attachments could damage the radio and may violate FCC regulations.

2.2.2 Approved Accessories

This radio has been tested and meets the FCC RF guidelines when used with the M/A-COM accessories

supplied or designated for use with this product. Use of other accessories may not ensure compliance with

the FCC’s RF exposure guidelines, and may violate FCC regulations.

For a list of M/A-COM approved accessories refer to the product manuals, M/A-COM’s Products and

Services Catalog, or contact M/A-COM at 1-800-368-3277.

2.2.3 Contact Information

For additional information on exposure requirements or other information, contact M/A-COM, Inc. at 1-

800-528-7711 or at http://www.macom-wireless.com.

9

Contents

Main MM23016 MANUAL REVISION HISTORY Page Page Page 1 SAFETY SYMBOL CONVENTION MM23016 2 RF ENERGY EXPOSURE INFORMATION 2.1.1 Federal Communications Commission Regulations 2.2 COMPLIANCE WITH RF EXPOSURE STANDARDS Page 3 OPERATION SAFETY RECOMMENDATIONS 3.1 TRANSMITTER HAZARDS 3.2 SAFE DRIVING RECOMMENDATIONS 4 OPERATING RULES AND REGULATIONS 4.1 OPERATING TIPS 5 PRODUCT DESCRIPTION 5.1 REMOTE CONTROL HEAD OPERATION Page 6 OPENSKY OPERATION 6.1 CH721 FRONT PANEL COMPONENTS Page MM23016 6.2 POWER UP AND VOLUME CONTROL 6.2.1 Power Up 6.2.2 Volume Control 6.3 SELF-TEST 6.4 LOGIN TO THE NETWORK 6.5 LOG OFF THE NETWORK 6.6 TURNING THE RADIO OFF 6.7 MENU DISPLAY AND CONTROL AREA MM23016 6.8 RADIO STATUS ICONS 6.9 DWELL DISPLAY 6.10 PERSONALITY 6.10.1 Profiles MM23016 6.11 ALERT TONES 6.12 BASIC MENU STRUCTURE Table 6-4: Basic Menu Structure MM23016 6.13 DUAL-TONE MULTI-FREQUENCY 6.14 KEYPAD COMMANDS (SYSTEM MODEL CONTROL HEAD) 6.14.1 Password Entry 6.14.2 DTMF Overdial 6.15 CHANGING THE ACTIVE PROFILE 6.16 CHECKING OR CHANGING THE SELECTED TALK GROUP 6.17 ADJUSTING DISPLAY & BUTTON BACKLIGHT BRIGHTNESS 6.18 STEALTH MODE MM23016 6.18.1 Enabling Stealth Mode 6.19 DIO LEVEL ADJUSTING SIDE TONE AU 6.20 CHANGE OPERATING MODE MM23016 6.21 ITTING VOICE CALLS 6.2 JUSTING AUDIO TREBLE LEVEL RECEIVING AND TRANSM 1.1 Receiving a Voice Call 6.24 TALK GROUP LOCK OUT MM23016 6.24.1 Lock Out a Talk Group 6.24.2 Unlock a Talk Group 6.24.3 Caution Regarding Profile Changes 6.25 SCANNING MM23016 6.25.1 Checking or Changing Active Scan Mode 6.25.2 Scanning Priority MM23016 6.26 MAKING SELECTIVE CALLS 6.26.1 Manually Dialing a Selective Call (System Model Control Head) 6.26.2 Speed Dialing a Selective Call MM23016 6.26.3 Receiving a Selective Call 6.27 SELECTIVE ALERT 6.27.1 Sending Selective Alert Messages MM23016 6.27.2 Receiving Messages 6.27.3 Defining Pre-Programmed Messages MM23016 6.28 TELEPHONE INTERCONNECT CALLS (SYSTEM MODEL CONTROL HEAD) 6.29 EMERGENCY COMMUNICATIONS 6.29.1 Declaring an Emergency Call or Alert MM23016 6.29.2 Silent Emergency 6.29.3 Clearing an Emergency Call or Alert MM23016 6.29.4 Receiving an Emergency Call 6.29.5 Dismissing an Emergency Call MM23016 6.30 ENCRYPTION 6.30.1 Automatic Encryption 6.30.2 Manual Encryption (System Model) 6.31 PRESET BUTTONS 6.32 DYNAMIC REGROUPING 6.33 GPS COORDINATES Page 7 BASIC TROUBLESHOOTING Page 8 TECHNICAL ASSISTANCE 9 WARRANTY APPENDIX A KEYPAD REMAPPING