MM23772, Rev. B

55
MESSAGE NAME DESCRIPTION
TXEMER Transmit
Emergency Indicates an emergency call has been transmitted on this radio. This
message will be flashing on line two.
VOL=31 Volume Level Indicates the current volume level. The volume level display ranges
from OFF (silent) to 31 (loudest).
WHC Who Has
Called Indicates an individual call has been received, but not responded to. The
indicator turns OFF if the individual call mode is entered, the system is
changed, or the radio is turned off and then on again.
UNKNOWN Unknown ID Indicates an individual call is being received from an unknown ID.
8.7 ERROR MESSAGES
If either of the Error Messages shown below is displayed, the radio is programmed incorrectly or needs
servicing.

DSP ERR

ERR=XXXX

(PowerUp
only)
or DIG V x

ERR x

Where: xxxx is the error code and DSP ERR or DIG V ERR is the message.
8.8 ALERT TONES
The P7200 radio provides audible Alert Tones or “beeps” to indicate the various operating conditions (see
Table 8-2).
Table 8-2: Alert Tones
NAME TONE DESCRIPTION
Call Originate one short mid-pitched OK to talk after pressing the push-to-talk
button
Call Queued one high-pitched Call queued for processing
Autokey one mid-pitched Queued call received channel assignment
System Busy three low-pitched System busy or unable to complete call
Call Denied one low-pitched Radio is not authorized on the system or
group
Carrier Control
Timer five high-pitched/one long low-
pitched PTT depressed for maximum length of time
Low Battery one low-pitched/one short mid-
pitched Low battery
TX Low Battery
Alert one low-pitched After PTT - battery too low to transmit