2075R Refrigerator and 2075RF Refrigerator/Freezer | ™ |
| |
|
|
Figure 12 |
Figure 13 |
Full Overlay Door Panel
Door Panel Preparation
A full overlay door panel completely covers the doorframe and handle to give a
1.Cut the overlay to the following dimensions (see Figure 15).
Full Overlay Dimensions:
3.Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, moving toward the edge (see Figure 13). This may take some force. Do not remove the three screws behind gasket.
4.Remove two outside screws holding door handle. Slightly separate door handle from door (see Figure 14).
5.Pull handle up and off.
6.Remove and discard existing panel and cardboard spacer.
7.Slide custom door panel insert into
8.Holding door gasket out
of the way, replace handle | Figure 14 |
on door, making sure it is |
|
seated properly on insert |
|
and that screw holes |
|
line up. |
|
9.Install two small screws removed in Step 4.
10.Starting at the corners and working inward, push door gasket into place on door.
11.Place door on bottom hinge pin and install upper hinge screw.
12.Reinstall the door shelves by lining up the bosses and first pushing straight in, then down at a 45° angle (see Figure 34 on Page 14). Go on to 5 Adjust Door.
Width:
Height:
The door panel must not weigh more than 20 lbs.
3/4" |
|
13/16" |
|
1/8" |
|
1/8" |
|
Relief Notch |
|
for Pivot Plate |
|
Rear View | |
of | |
Wood Panel |
|
| |
Figure 15 |
|
IMPORTANT
Rear View of wood panel for
2.Create a relief (Figure 15) for pivot plate by cutting notch in top corner and coinciding back corner of overlay panel. Refer to Figure 16 for exact specifications.
8 | 02/2005 |
