U-Line B12115, B198, ADA151M Removing and Installing Grille, Removing and Installing Door Shelves

Removing and Installing Grille

WARNING

Disconnect electric power to the unit before removing the grille.

WARNING

DO NOT touch the condenser fins(4). The condenser fins are SHARP and can be easily damaged.

Removing the grille.

1.Disconnect power to the unit.

2.Remove control knob (6) if equipped.

3.Loosen the two screws (1). Some models may have only one screw in the center.

4.Remove grille (2) and grille cap (if equipped)(3) from unit.

Installing the grille:

1.For 15 and 29 models make sure grille cap (3) is behind grille in slots (2) provided in grille before attaching grille to unit.

2.For 75 models place the hook-hinge located on the rear bottom side of the grille (2) onto the front lip of the unit base. Swing the grille up into position.

3.Align cabinet and grill holes and secure, but do not overtighten grille screws (1).

4.Install control knob (6) if equipped.

5.Reconnect power to the unit.

29 Models

3	1
6	2

Ice Maker Models

2 1

4

61

2

5

Removing and Installing Door Shelves

1

2

For models equpped with door shelves:

To remove the door shelf:

1.Grasp shelf in center, and lift until the shelf notches (1) clear the pins (2).

2.Carefully pull the shelf away from the door.

To install the door shelf:

1.Holding the shelf in the center, center the shelf in the door at the desired location, slightly above the pins (2).

2.Lower the shelf onto the pins (2).

U-Line Combo® Models and Ice Makers Maintenance 9