Install the insert as follows:
!WARNING
Insert edges may be SHARP! Use care when installing.
1.Remove top hinge screw pin (7/64" Allen wrench, see Figure 22). Remove door by tilting forward and lifting off bottom hinge pin.
2.Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, mov- ing toward the edge (see Figure 23). This may take some force. Do not remove the three screws behind gasket.
3.Remove two outside screws hold- ing door handle. Slightly separate door handle from door (Figure 24).
4.Pull handle up and off. Remove outer door panel and cardboard spacer.
5.Slide custom door panel insert into 1/4" channel in door front.
6.Holding door gasket out of the way, replace handle on door making sure it is seated prop- erly on insert and that screw holes line up.
7.Install two small screws removed in step 3.
8.Starting at the corners and working inward, push door gasket into place on door.
9.Place door on bottom hinge pin and install upper hinge screw.
UL310
Figure 22
DWR020
Figure 23
UL132
Figure 24
21