User’s Manual

The CLRCO2075 can be installed using a gravity drain or can use a factory installed or equivalent drain pump.

Follow these guidelines when installing drain lines to prevent water from flowing back into the ice maker storage bin and/or potentially flowing onto the floor causing water damage:

Gravity Drain

Drain lines must have a 5/8 inch inside diameter.

Drain lines must have a 1 inch drop per 48 inches of run (1/4 inch per foot) and must not create traps.

The floor drain must be large enough to accommodate drainage from all drains.

Insulate the bin drain line to prevent condensation.

CLRCO2075 With Factory Installed Drain Pump

NOTE

Before installing your U-Line CLRCO2075 With Factory Installed Pump, it is extremely important to check and test all hose connections at the drain pump. There is a possibility that hose connections may have loosened during shipment.

!WARNING

To prevent accidental electrocution, make certain that the floor surfaces surrounding the unit are dry whenever power is removed from, or applied to the unit.

1.Make certain the unit is not plugged into an electrical outlet.

2.Carefully push the power cord grommet (Figure 2) through the hole in the back panel.

WATER

DRAINCLRCO002

Figure 2

6