Install the insert as follows:
!
Insert edges may be SHARP! Use care when installing.
1.Remove top hinge screw pin (large Phillips head, Figure 18). Hold door to keep it from falling.
2.Remove door, being careful not to scratch top of door on hinge.
3.Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, moving toward the edge (Figure 19). This may take some force.
Figure 19
UL131
Figure 18
4.Remove two small screws
holding door handle. Slightly separate door handle from door (Figure 20).
5.Pull handle up and off.
UL132
Figure 20
21