User’s Manual

NOTE

Use care not to bend light switch bracket (where installed), located on door bottom when installing door insert. Do not set door on bottom edge when pushing insert into place.

6.Slide custom door panel insert into 1/4" channel in door front.

7.Holding door gasket out of the way, replace handle on door mak- ing sure it is seated properly on insert and that screw holes line up.

8.Install two small screws removed in step 4.

9.Starting at the corners and working inward, push door gasket into place on door.

10.Place door on bottom hinge pin and install upper hinge screw (Figure 19).

11.Reinspect door seal and alignment. Adjust if needed.

WOOD TRIM ON WINE RACKS

Your 75 BEV is equipped with a natural wood trim on the wine racks. For appearance and durability, the wood trim has been coated at the factory with a clear vinyl sealer, which will adequately protect the wood in normal usage.

!WARNING

To prevent permanent damage to the inner liner of your 75 BEV, the wine rack wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the stain/finish manufacturer’s instructions prior to re-installing the wood trim inside the cabinet of the 75 BEV. Failure to do so may cause the inner liner of the unit to have a permanent odor, which is not covered by the warranty.

You have three options regarding the wood trim on the wine racks.

(1)You can leave as is, (2) add a final finish coat or (3) you may stain the wood trim. The final finish coat was not applied at the factory so that the wood trim could be stained. YOU CANNOT STAIN THE WOOD TRIM ONCE YOU APPLY THE FINAL FINISH. Review the following guidelines when staining and or sealing the wood to ensure proper adhesion and durability of the finish.

22