www.ultramagicard.com
300 & Sprinter
Special Note:
How to fit UR3 Continuous Resin Dye Film and UR10 Single Colour Dye Film
Before fitting the continuous resin black thermal transfer film dye film or the UR10 single colour dye film a small modification must be carried out on the
As this dye film has no panels the optical sensors are inoperative, so for correct operation it is important that this modification is carried out.
Please Note: Should you revert back to using any other dye film this modification must be reversed.
The modification is performed as follows: | 1 |
|
Switch off the Magicard printer and lift up the Mechanism Top Cover to the vertical position and remove the dye film and
ON PRINTERS WITH WHITE PLASTIC DYE FILM TAKE-UP GEAR
Remove the steel pin, which normally engages with the recess in the dye film
This pin is a press fit in the dye film
It may be removed by means of a pair of pliers or a small "Mole" |
|
| 2 |
|
|
| |
|
|
| |
wrench, using a twisting and pulling action to remove it. |
|
|
|
With each new roll of continuous black dye film, a rubber washer |
|
|
|
is provided, this washer should be fitted on the plastic dye take- |
|
|
|
up spigot adjacent to the large spur gear, and before fitting the |
|
|
|
dye film |
|
|
|
ON PRINTERS WITH BLACK DYE FILM |
|
|
|
Using a Phillips head screwdriver, turn the locking |
|
|
|
3 |
|
| |
screw on the centre of the dye film |
|
| |
|
|
| |
|
|
| |
|
|
| |
in the recess in the dye film |
|
|
|
flush with the dye film |
|
|
|