Ultratec LSX Low smoke converter Before Requesting Service, Recommended Fluids, Maintenance Fluid

Before Requesting Service

If LSX will not Power Up	Check Power source and connections
Green ‘LED’ is not illuminated & Red ‘LED’ is	Low Pressure Switch has tripped, allow for Auto Reset
illuminated
Low Pressure Switch will not Auto Rest. Red ‘LED’	Low Refridgerant Charge (Contact Local Dealer)
remains illuminated
Fog will not remain on ground	1.	Ensure the use of Ultratec Special Effects Fluid
	2.	Check digital temperature display reading for coil
		temperature
	3.	Check Green and Red ‘LED’ see above
Green ‘LED’ goes out when unit is operating and	Check Power Source for sufficient voltage. Do NOT use
Red ‘LED’ doesn’t illuminate	extension cords.
Condensation on floor / Floor seems slippery	4.	Too much fog going through LSX
	5.	Fog machine nozzel is too close to LSX
	6.	Reduce fog output, or duration

Recommended Fluids

Molecular Fog Fluid: A faster dissipation versus the Director’s Choice Fog Fluid. This thick, clean, white fog is an optimal solution for a dense low-lying fog effect when chilled with the LSG or LSX machines.

Maintenance Fluid

EZ Kleen Preventative Maintenance Fluid: Using EZ Kleen preventative maintenance fluid on a regular basis ensures longer life for the heat exchanger in Ultratec fog machines by reducing blockage.

All of our Fog Fluids are water based. Damage will occur if Haze Fluid is used.

6 www.ultratecfx.com