wires of 1,2,3,6 are reversed so that wire 1 become 3 at the other end of the cable, 2 becomes 6, and so forth.
To determine which wire is wire 1, hold the RJ-45 plug with the spring clip facing towards the ground and the end pointing away from you. The copper wires exposed upwards to your view. The first wire on the far left is wire 1. You can also refer to the illustrations and charts of the internal wiring on the following page.
Figure 3-1 shows the diagram of Straight Through Cables. Figure 3-2 shows the diagram of Crossover Cables.
Figure 3-1: Straight Through Cabling
Figure 3-2: Crossover Cabling
2.2 Rear View
Figure 2.1-1 illustrates the rear panel of the MicroGST-5Switch; Figure 2.1-2 illustrates the rear panel of the MicroGST-8Switch.
Table 2.2-1 shows the port function of both switches.
Figure 2.2-1
Figure 2.2-2
Port | Function |
1000Base-T Ports | |
5-Port:Ports 1–5 | These 5/8 Gigabit ports connect to network |
8-Port:Ports 1–8 | devices such as PCs, print servers and other |
| network peripherals at 1000 Mbps. |
| |
Power Connector | This is where you will connect the AC |
| power adapter. |
| |
| Table 2.2-1 |
