Uniden DX 834 Series - page 16

Setting Up Your Phone

Extending the Antenna

Before using your phone, be sure to raise its antenna to the vertical position. Then, fully extend the

antenna.

Installing the Handset Battery Pack

1. Press in on the Battery Cover Release

2. Slide the battery compartment cover down.

3. Align the plastic connector of the Nickel-

Cadmium battery pack with its socket and plug iit in.

Note: The black lead will be on the left when the

plug is properly aligned

4. Place the battery pack inside the battery com-

partment and slide the battery cover back on.

Note:The built-in Memory Backup feature allows up

to 3 minutes to disconnect the old battery pack and

install a new one without losing any numbers

stored in memory.

Extend

16 DX834

DX834OM.qxd 4/12/98 11:49 Page 16

Contents

Main WARNING! Page Important Safety Instructions 4DX834 Page Introduction Voice Scramble The UltraClear Plus AutoTalk Page Page DX 834 Series Important Electrical Considerations 10 DX834 Page Page Wall Installation Direct Wall Mounting Note: Do not use an outlet controlled by a wall switch Page Page Cleaning the Battery Contacts Charging the Battery Pack Low Battery Indicator Note: Allow 15-20 hours without any interruption for the Handset to fully recharge. Setting the Pulse-Tone Switch (Australian Model only) Adjusting Ringer Controls Adjusting Handset Receiver Volume Using Your Phone Changing Channels, Flash and Page/Find Note: The Making and Receiving Calls procedure will drop the current call connection and pick up the incom- ing call or the call on hold. Programming Your Phone Storing A Number in Memory Storing a Mixed Number 20 DX834 Dialing a Stored Number Chain Dialing Erasing a Stored Number Troubleshooting 22 DX834 Specifications (For Australian Model only) Specifications (For New Zealand Model only) 24 DX834 Warranty