Uniden EXA 7950 Chain Dialing, Erasing a Stored Number from Memory, One-touch priority dialing

▼One-touch priority dialing

Your phone is equipped with three “One-Touch Priority” keys for instant dialing. You cannot store phone numbers directly into m1, m2 or m3. They are only used to dial phone numbers stored into memory locations 1, 2 and 3. (See “Storing a Phone Number in Memory,” page 13.)

NOTE

To instantly dial phone numbers stored in memory locations 1, 2 or 3, simply press m1, m2 or m3. (There is no need to press talk; the phone will automatically dial.)

7pqrs 8tuv 9wxyz

tone

0oper #

redial pause chan volume

m1 m2 m3

m1, m2, m3

An error sounds and the erase procedure will be canceled if more than 20 seconds elapse between each keystroke.

If you press m1, m2 or m3, and no phone number was stored in memory locations 1, 2, or 3, the phone will beep rapidly but will not dial.

CHAIN DIALING

On certain occasions after dialing a number, you may be requested to enter an access code, such as your account number. You can enter this number into a memory location for later use by doing the following.

1)Store the access code into one of the memory locations (0-9) or memory keys m1, m2, or m3 following the steps above.

2)Dial the party or service main number.

3)When you need to enter the special number, press mem followed by the memory location (0-9) or memory keys m1, m2, or m3

ERASING A STORED NUMBER FROM MEMORY

1)Remove the handset from the base unit.

2)Press the mem button twice.

3)Press the memory location (0-9). A tone indicates that the stored number is erased from memory.

You cannot erase the phone numbers from memory locations 1-3 by pressing the m1 - m3 keys. You must

NOTE use the keypad (1-3) for these locations.

14