Find Handset
To locate the handset (while it’s off the base), press the find hs key on the base. The handset beeps for 60 seconds.
Paging is canceled when pressing any handset key, the find hs key on the base or the handset is returned to the base.
NOTE: Paging is also canceled when the phone receives an incoming call.
Flash and Call Waiting
If you have “Call waiting” service and a call waiting tone sounds while you are on a call, press the flash key to accept the waiting call. There is a short pause, then you will hear the new caller. To return to the original caller, press the flash key again.
NOTE: You must subscribe through your local telephone company to receive Call Waiting Service.
Storing a Phone Number in Memory
Your cordless phone has 1 RocketDial memory location and 10 additional memory locations for storing important telephone numbers. You can store your most frequent dialed number in the
1) Press the m/mem key in standby mode. The talk/batt low LED flashes.
2) Enter the phone number by using the keypad, 
/tone or #, up to 20 digits. If a pause is needed during the dialing sequence, press the redial/pause key to insert a pause. Each pause counts as a digit and represents a two second delay in time between digits as they are sent.
3) Press the m/mem key again.
To actually store a number in its designated location;
4)Press the RocketDial key.
or
4)Press memory location
A tone indicates that the number is stored. If you enter a number in a location that has a previously stored number, it will overwrite the existing number without warning.
NOTE: • The pause key counts as one digit. Pressing the redial/pause key more than once increases the length of pause between numbers.
•In memory storing operation, you must press a key within 30 seconds or the handset will beep rapidly and the phone will return to standby mode.
•Memory location for the RocketDial is independent from the memory locations for Memory Dial.
Dialing a Stored Number
Using the memory location features
1)Press the talk key in standby mode, then press the m/mem key.
2)Enter the memory location
NOTE: If you select a memory location that does not have a stored number, the handset will beep rapidly and the phone will not dial.
6
