Loop(PLL) techniques to provide crystal controlled transmit and receive operation on all 10 channels. The PLL circuitry assures ultraprecise fre- quency control. It is designed to meet the Department of Communications requirements applicable to equipment operating in the Inshore Boating Radio Communication Service, and is not to be used for any other purpose, RB244 of the D.O.C. regulations defines operation in this service, and you are required to read and understand these regulations prior to operating this equipment.
INSTAllATION
Location
Plan the location of the transceiver and microphone bracket before starting the
installation. Select a location that is convenient for operation and does not interfere
with the driver or passenger in the vehicle. In automobiles, the transceiver is usually mounted to the dash panel with the microphone bracket beside it.
Mounting and Connection
This radio is supplied with a universal mounting bracket. The transceiver is held in the bracket by the two thumb screws supplied, permitting adjustment to the most convenient angle. The bracket must be mounted with the machine screws supplied.
The mounting surface must be mechanically strong. Proceed as follows to mount the transceiver:
1.After you have determined the most convenient location in your vehicle, hold the radio with mounting bracket in the exact location desired. If nothing interferes with mounting it in the desired position, remove the mounting bracket bolts. Before drilling the holes, make sure nothing will interfere with the installation of the mounting bolts.
2.Connect the antenna cable plug to the standard receptacle on the rear panel. Most
CB antennas are terminated with a type
3.Connect the DC power input wire with the fuse (red) to +12V DC. This wire extends from a plug which connects to the rear panel.
This prevents the set being left on accidentally when all persons leave the vessel and also permits operating the radio without the engine running.
