Uniden TCX860 owner manual Installing Your Expansion Handset, Install the Battery Pack

Installing Your Expansion Handset

Follow these three easy steps to get your new handset ready to use:

1 Install the battery pack.

2 Connect the charger and charge your new handset for 15-20 hours. 3 Register your new handset to the main base.

Step 1: Install the Battery Pack

1 Press down on the handset battery case cover (use the finger indention for a better grip) and slide the cover downward to remove.

2 Plug the battery pack connector (red & black wires) into the jack inside the battery compartment.

(The connector notches fit into the grooves of the jack only one-way.) Match the wire colors to the polarity label in the battery compartment, and push the connector in until you hear a click.

3 Make sure you have a good connection by slightly pulling on the battery wires. If the connection is secure, the battery jack will remain in place.

4 Place the battery case cover back on

the handset by sliding it upwards until it clicks into place.

5 Place the handset in the charging cradle with the keypad facing forward.

•Use only the Uniden battery (BT-446)

supplied with your phone. Replacement batteries are also available through the Uniden Parts Department. (See page 2.)

• Recharge your handset on a regular basis by returning the handset to the charger after each phone call.

Rechargeable Nickel-Metal-Hydride Batteries

Must Be Recycled or Disposed of Properly

– 3 –