Getting Started
Install the Base
The following tools are required:
•Electric Drill
•5mm Drill Bit
•No. 2 Philips Screwdriver
1.Hold the base of the camera stand where you want to mount it and mark the location of the screw holes.
2.Use the included screws and anchors to attach the base to the wall or ceiling. You can also screw the base into a flat surface such as a tabletop if needed.
3.Before attaching the camera, tug gently on the stand to make sure it is securely in place.
Attach the Camera
1.Attach the camera bracket to the mounting screw. You can attach the stand to the top or the bottom of the camera as needed.Tighten it a few turns, then turn the camera to face the direction you want.
|
| Tighten the brace against | 1 | Attach the camera | |||||||
2 |
| to the mounting | |||||||||
| the camera to |
|
| screw and turn it | |||||||
|
| secure it |
|
| to the desired | ||||||
|
| in place. |
|
| direction. | ||||||
3 |
|
|
|
|
|
|
|
|
|
| |
Loosen the |
|
|
|
| |||||||
wingnut to |
|
| Adjust the post to | ||||||||
unlock the |
|
| 4 | ||||||||
|
|
|
| ||||||||
mounting | the correct angle, | ||||||||||
post. |
|
|
|
|
|
|
|
| then tighten the | ||
|
|
|
|
|
|
|
|
|
| wingnut to lock the | |
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| post into place. | |
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2.Tighten the camera brace up against the camera to secure it into place.
3.Unlock the mounting post by turning the wingnut to the left a few turns.
4.Set the mounting post to the correct angle, then tighten the wingnut until the post is locked into place.
5.Attach the antenna to the rear of the camera.
6.Connect one end of an AC adapter to the camera’s power pigtail and plug the other end into a 120 volt AC (standard indoor) power outlet. (If necessary, connect the extension cord to the camera’s pigtail and connect the AC adapter to the extension cord.)
5
