Selecting a Channel, To Transmit and Receive | Uniden UH036SX

SELECTING A CHANNEL

Press channel	or	to select the
desired channel.

TO TRANSMIT AND RECEIVE

ch/	dup	vol/
scan		mon
		mic

The UH036SX uses the 40 UHF-CB Channels. For your reference a list of the available channels and corresponding frequencies is printed on page 10.

1.	The transmit power of the
	UH036SX is 500mW which will	PTT
	provide a range of up to 3+Km.	PTT
2.	provide a range of up to 3+Km.	Switch
2.	Before you transmit, listen for
	activity on the selected channel.
3.	When the channel is clear, press and hold the
	to transmit. TX appears on the LCD.

ch/	dup	vol/
scan		mon
		mic

PTT

Hold the radio with microphone approximately 5 cm in front of your mouth with the antenna at approximately 45° angle away from your head. Speak in a clear, normal conversational voice.

4. When you have finished speaking,
release the PTT . TX then disappears on
the LCD. Listen for a response.	TX

While receiving, the RX icon is displayed.

5

Image 6

Uniden UH036SX Selecting a Channel, To Transmit and Receive, Press channel, Desired channel, Provide a range of up to 3+Km

Contents

Operating Guide Control & Indicators Included in Your UH036SX Package Make sure your radio is off Remove the battery cover Battery WarningBattery Installation Replace the battery cover Belt Clip LOW Battery AlertWater Warning Slide the belt clip until it snaps into place Adjusting the KEY Beeps Power ON/OFFVolume Operation Press channel Selecting a ChannelTo Transmit and Receive Desired channel Range Maximum Range Reduced Range To return to normal receive mode press Volume Once Automatic Squelch FeaturePress and hold Volume Monitor To Operate in Duplex Mode ScanningStarts Press Channel DROP-OUT Delay Power Save UHF Channels & Frequencies Warranty Uniden UH036SX UHF CB Radio