Unigreen CAMPO 11 - 16 - 22 - 32 manual Work Stations, Hand Washing Tanks, Preliminary Checks

4.1.1 WORK STATIONS

The use of this machine does not envisage an operator standing constantly near the same, the operator normally sits in the cab of the tractor.

During calibration and maintenance operations the operator will be working near the machine at ground level (for all the calibration and maintenance operations refer to the relevant chapters).

In case of operations that request the entry to parts of the machines located at 1,5 mt. height ,it is advised to use a ladder at rule; the ladder shall be positioned steady on a flat ground not yielding and with the machine at a standstill and braked.

In some special models with controls above 1.5 metres there is a platform to make these operations easier.

This platform must only be used with the machine stopped.

NOTE: Put the ladder back into the correct operating position after use, securing it with the hook; make sure not to pinch or crush your hands during these operations.

4.1.2 HAND WASHING TANKS

The sprayers are supplied with an auxiliary hand-washing tank with clean water and a hand tap.

This tank must always be supplied with water and the inside must be clean so you can wash any parts of the body that come into contact with the chemical product used.

Never drink the liquid inside.

4.2PRELIMINARY CHECKS

When you receive the machine, check that it is complete and no parts are missing.

If there are any damaged parts, inform your local reseller or UNIGREEN directly in good time.

When the machine is delivered, make sure you ask:

a)that the machine is delivered with all of its parts fitted and that the fitting meets the requisites in table N° 12 pag. 33-34. (This procedure is necessary because for reasons of space during transportation the machine is often delivered partially dismantled).

b)that it is tested in your presence in particular checking:

=that the suction filter and the inside of the tank are clean and free of work residues.

=that the connections are made correctly following the basic layout (FIG. N° 11).

=that the hose clips and all the unions and connections are tightened properly.

=that any herbicide boom is mounted in the centre.

=that all of the protective covers are fitted solidly to the machine, in particular the protective cover of the power-takeoff of the pump.

=Check the proper tyres inflation (pressure are indicated on tyres)

4.3TRANSPORTING AND MOVING THE MACHINE

Every time you have to lift the machine, before starting the operation, always make sure the lifting gear and the relevant tools and equipment (cables, hooks, etc..) are suitable for lifting the load and check the stability of the same.

It is forbidden to unhook and move the machine with the tank full.

The dry weight of the machine at the maximum level of fitting and with all the accessories allowed is stamped on the nameplate (Fig. 2); use slings and lifting gear with a adequate load-bearing capacity.

Don’t stand the sprayer on soft ground or steep slopes.

Never lift or move the sprayers by hand if there is liquid in the tank. The machine will weigh more and the movement of the liquid can change the centre of gravity causing uncontrolled movements.

We recommend using slings as shown in the figure, the lifting points to use on the machine are indicated with the relevant symbol.

Don’t lift the machine with the forks of a forklift truck because the machine can tip over due to the overhanging weight of the booms.

Don’t pass or stand under the machine when it is being lifted.

This symbol identifies the clean water tank on the machine used to wash your hands

This symbol identifies the coupling points of the machine

unigreen 9