Universal 35-R owner manual Specifications, Ventilation, Contents, Foryoursafety

SPECIFICATIONS

MODEL NO.	............ 35-R
GAS TYPE	LP-Gas
MAX. INLET
PRESSURE	22 in. w.c.
MIN.INLET
PRESSURE	22 in. w.c.
MANIFOLD
PRESSURE	21 in. w.c.

Do not exceed the gas supply pressures shown on rating plate for Model 35-R. The maximum inlet gas supply pressure and the minimum inlet gas supply pressure (for purposes of input adjustment) for LP-Gas are shown as follows:

WARNING

DO NOTEXCEED 0.78 psi (22” w.c.) GAS PRESSURETOTHEGASCONTROLVALVE.

VENTILATION

WARNING

THISAPPLIANCEISUNVENTEDANDMUSTBE USEDONLYINAWELLVENTILATEDAREA.

The flow of combustion and ventilation air must not be obstructed. DO NOT use in a tightly enclosed area. Any combustion process requires and consumes oxygen, and may produce carbon monoxide. This heater must be operated with adequate ventilation. Two openings directly to the outdoors must be provided, one low and one high, preferably on opposite sides of the area to be heated. Each of these openings must provide at least three square inches of combustion air-intake area and exhaust outlet area for every 1000 BTUs per hour of heater input rate in order to complete the combustion/ventilation process. Provide additional ventilation for any additional fuel-burning appliances and/or additional occupants.

CLEARANCE(Minimumclearancestocombustiblematerials)

MODELNO.	BTU/HRRATING		NORMALOPERATING		CLEARANCESTO
	TYPEGAS		POSTION		COMBUSTIBLES
	NATURAL	LP & NG		TOP	SIDES	BACK	FRONT
35-R		35,000*	VERTICAL	40”	40”	0”	54”

*Tank size and tank temperature can directly affect BTU output

CONTENTS
Installation Instructions	3
Location	3
Piping	3
Odor Fade Warning	4
Operating Instructions	5
Lighting and Shut Down	5
Maintenance Instructions	6
Replacement Parts List	8
Service and Parts Ordering Information	9

FORYOURSAFETY

Do not use this heater in a space where gasoline or other liquids having flammable vapors are stored or used.

The heater is designed and approved for use as a construction heater under ANSI Z83.7 / CGA 2.14 - 2000

We cannot anticipate every use which may be made of our heaters.CHECKWITHYOURLOCALFIRESAFETYAUTHORITYIF YOUHAVEQUESTIONSABOUTAPPLICATIONS.

Other standards govern the use of fuel gases and heat producing products in specific applications. Your local authority can advise you about these.

This appliance is intended to be used primarily for the heating of buildings under construction, alteration or repair.

THESTATEOFCALIFORNIAREQUIRESTHEFOLLOWINGWARNING:

WARNING

Combustion by-products produced when using this product contain carbon monoxide, a chemical known to the State of California to cause cancer and birth defects (or other reproductive harm).

2 Operating Instructions and Owner’s Manual