3
Using the MAIN Menu
The MAIN Menu enables you to either select a new Activity or simply select a new Device to control.
When you select a new activity, the Home Theater Master will issue a MACRO (a timed sequence of many commands from many different remote controls). This MACRO was custom programmed for your system by your installer. It will issue all of the commands necessary to switch the sound and picture of your system.
When you select a device, the Home Theater Master becomes the remote control you select WITHOUT affecting the home theater.
Select a New ACTIVITY
1.Touch the MAIN button to make sure that you are on the MAIN Menu. Touch the PAGE button if you don’t see the activity you want.
2.Point the Home Theater Master at the system (or at the repeating INFRARED sensor if one is installed).
3.Touch the activity button next to the desired screen label. For exam- ple if you wish to watch a DVD movie, touch the DVD button.
4
Hold the remote steady and pointed at the system until the sound
and picture have been switched.
The MAIN Menu buttons issue MACROS that reset the sound and picture of your home theater to a new activity.
TIP – Hold the remote control steady and pointed at the sys-
tem until the 
indicator stops flashing.
If the sound or the picture still are not correct, repeat steps 1 - 4.
Select a DEVICE Only
1.Touch the MAIN button to make sure that you are on the MAIN Menu. Touch the Page button if you don’t see the activity you want.
2.Press and hold the MAIN button. While holding the MAIN button down, touch the button next to the desired screen label. The remote control will now display the name of the selected device and all buttons will operate the device, however, the sound and the picture of your sys- tem have not been changed.