MX-890 COLOR LCD SCREEN

Connecting the Battery Pack

Unlock the rear cover by pressing down on the spring lock at the top of the cover. Remove the cover. For shipment from the factory, the battery is left out of the MX-890. Place the battery into the battery compartment, making sure you align the contacts on the battery to the contacts on the MX-890. The battery will snap into place when aligned properly. Replace the cover and snap it into place.

Using the Charging Base

Plug the 5V adapter into a power outlet and into the back of the charging base.

Gently place the MX-890 into the cradle of the charging base. It automatically aligns itself

to the contacts on the charging base.

The Status light should immediately light. Red indicates that it is charging. Blue shows that it is fully charged. There is no harm in leaving the MX-890 on its charging base whenever it is not in use.

Optionally, the 5V power adapter can be plugged directly to the bottom of the MX-890.

Red indicates charging, Blue that the remote is fully charged.

Resetting the MX-890

Normally, resetting the MX-890 is not necessary. However, if you notice unusual behavior, press the reset button within the battery compartment. Press the Reset button to cycle the MX-890’s power and reboot the unit.

Page 3