Universal Remote Control URC 4021 warranty RE-ASSIGNING Device Keys, Using Channel Scan

PROGRAMMING A MASTER POWER MACRO (continued)

Clearing The Master Power Macro

1.Press and hold SET until the LED (red light) blinks twice, then release SET.

2.Enter 9 - 9 - 5. The LED will blink twice. Then press POWER once.

3.Press and hold SET until the LED blinks twice, then release SET. The Master Power Macro is now cleared.

RE-ASSIGNING DEVICE KEYS

The One For All 4 Device Universal Remote Control can be set to control a second PVR,VCR, or DVD player. For example, to control a TV, a cable box, and two DVD players, re-assign the unused VCR/PVR key to operate the second DVD player as follows:

1.On the remote control, press and hold SET until the LED (red light) blinks twice, then release SET.

2.Enter 9 - 9 - 2. The LED will blink twice.

3.Press DVD once.

4.Press VCR/PVR once. The LED will blink twice. The VCR/PVR key is now ready to be set up to control your second DVD player. See Programming Device Control on page 8.

To re-assign a second VCR or PVR (or DVR) to the unused DVD key, repeat steps 1 through 4. However, in step 3 substitute VCR/PVR for DVD, and in step 4 substitute DVD for VCR/PVR. Now the DVD key will be ready to be set up as your second VCR or PVR (or DVR). See Programming Device Control on page 8.

NOTE: Only one device can be assigned to an unused device key at a time.

USING CHANNEL SCAN

In the CBL/SAT or TV mode, use the FAV key to start a 3-second scan of all channels. Or, if programmed, use the FAV key to scan only your favorite channels to view a desired channel (see Programming Favorite Channel Scan on next page. )

1.Press CBL/SAT or TV once.

11