1210DKA Alhambra Door Kit
INSTALLATION INSTRUCTIONS
CSA approved for use with Valor Model 1200 Heater ONLY
Note: This kit must be installed or serviced by a qualified installer, service agency or gas supplier. These instructions are to be used in conjunction with the main installation instructions for the 1200.
NOTE: To install the kit’s backing plate, the surface of the finished hearth or floor must be at the same level as the bottom of the heater. Please be aware that the backing plate mounting can ONLY accommodate 1/2” wall thickness.
The 1210DKA Alhambra Door Kit may be fitted to the Valor model 1200 heater, either at the time the heater is installed or retrofitted afterwards (provided existing wall and hearth finish
NOTE: The bottom of the plate is flush with the bottom of the heater. Bottom of the heater MUST be flush with or higher than the finished hearth.
Wall Finish
1210DKA Alhambra
Door Kit
(incl. magnet bracket)
Magnet
Bracket
1200 Heater
Backing Plate
Alhambra Doors
Overview
Mantel or Shelf Clearances
For Mantel of Shelf Clearances, see the Installation manual provided with the 1200DV Ventana engine.
© Copyright Miles Industries Ltd., 2007.