Vantec NBW-100U Activate / De-Activate Laser Point Function, Establishing a Communication Link

NBW-100U 2.4GHz Wireless Presenter User’s Manual

Activate / De-Activate Laser Point Function

The laser pointer function is de-activated by default. To activate this function, press and hold the Laser key & Mode key simultaneously for about 3 seconds until the LED flashes red to confirm activation. To de-activate the laser point, just repeat these steps.

+ = Activate / De-activate Laser Point Function

When laser point is activated, you can press and hold the Laser Light key to shoot the laser light and release the key to turn it off.

Note: If the batteries inside the presenter are replaced, you will need to re-activate the laser point function before you can use it.

Establishing a Communication Link

If your presenter is not working or RF interference with other remote device occurs, then you need to reset the ID shared by the presenter and the receiver so that they can establish a communication link. To reset the ID, make sure the receiver is plugged to a computer and take the steps below:

1.Press the Mode key in conjunction with the Mouse Left key for about 3 seconds until the LED flashes in green. Then release the keys.

Press simultaneously until the LED flashes.

2.Insert a pin or bent paperclip into the small hole on the receiver. Press it lightly and then release.

3.The reset is complete and now the presenter is ready to use. You can verify the link just using the mini stick to see if it controls the cursor.

Note: As the laser point function is independent from the receiver, it cannot be used to verify the link.

- 9 -