7
TERMINAL OR MOVING PART.
IF AUDIBLE ALARM SOUNDS - DO NOT TURN ON SAFETY SWITCH!
REVERSE POLARITY OF CLAMP CONNECTIONS
POSITIVE GROUND SYSTEMS
NOTE: In the rare event that the vehicle to be started has a Positive Grounded System (positive battery terminal is connected to chassis): Replace step 3 above with the following steps, and then proceed to steps
3a. Connect negative
3b. Connect positive (+) red clamp to vehicle chassis or a solid,
If audible alarm sounds - do not turn on safety switch reverse polarity of clamp connections
4.Turn jumpstart system ‘s power switch to ON position.
5.Start vehicle (do not turn key for longer than
6.After vehicle starts, turn jumpstart system ‘s power switch to OFF position. Remove clamps (disconnect the negative (Black) jumper cable first; followed by the positive (Red) jumper cable) and replace them in the
CAUTIONS:
1.If vehicle fails to start, leave vehicle ignition key turned OFF, disconnect the negative
2.Recharge jumpstart system after each use.
WARNINGS:
1.ALWAYS disconnect the negative (Black) jumper cable first; followed by the positive (Red) jumper cable.
2.NEVER ALLOW RED AND BLACK CLAMPS TO TOUCH EACH OTHER OR ANOTHER COMMON METAL CONDUCTOR — THIS COULD CAUSE DAMAGE TO THE UNIT AND/OR CREATE SPARKING/EXPLOSION HAZARD.
3.There is a risk of explosive gases being released when batteries are improperly charged or discharged. Failure to follow instructions may cause property damage, explosive hazard and/or personal injury.
4.ALWAYS USE PROTECTIVE EYEWEAR WHEN USING THIS PRODUCT: CONTACT WITH BATTERY ACID MAY CAUSE BLINDNESS AND/OR SEVERE BURNS.
5.Keep out of reach of children!!
6.ALWAYS store battery clamps in