4.CHARGING THE VECTORLITE USING AC RECHARGE ADAPTER
1.Locate the recharge port on the side of the spotlight (see figure 1).
2.Connect the charger to an appropriate AC power source.
3.Plug the charger's barrel connecter into the recharge port located near the handle. Note that the red LED lights to indicate that the battery is charging.
4.Recharge for 12 hours maximum.
5.After recharge, disconnect the adapter from the external charging source, then disconnect barrel connector from the recharge port.
6.After AC recharge, wait 5 minutes before using spotlight.
Recharging from an AC source requires the use of the AC/DC recharge adapter.
NOTE: DO NOT OPERATE THE SPOTLIGHT DURING AC RECHARGE. Make sure the AC outlet provides 110 to 120 VAC at 60 Hz.
CAUTION: Use the supplied AC recharge adapter; do not substitute with any other.
FIGURES 2A & 2B - AC AND DC RECHARGING ADAPTERS
AC RECHARGE ADAPTER
BARREL CONNECTOR
DC RECHARGE ADAPTER
DC PLUGS
CHARGING/OPERATING FROM A DC SOURCE
Plug the DC recharge/power adapter (included) into the DC accessory socket on the front of the spotlight body, and then insert the power cord into the 12 Volt DC power outlet socket of your vehicle or other 12 Volt DC power source. The spotlight may be operated while the internal batteries are being charged. Allow approximately 8 hours charging time. Recharge for the recommended time. Make sure the DC source (jump starter, battery pack, vehicle accessory socket, etc) is 12 Volt DC. For corded operation, the DC source should be able to supply at least 10 amps at 12Volt DC.
5