●
●
●Signal sensing auto turn on/off with bypass option
●Variable volume control
●Selectable phase control (0 or 180 degrees)
●Dual staggered
Installation
Your new DLS subwoofer system provides for a number of installation options. Read all the installation information below in order to determine which installation option is best for your system. Remember to perform
all installation procedures with system power turned off.
Inputs
Your new subwoofer is equipped with both
Note:
Do not use both the RCA/Phono "INPUT" connections and "SPEAKER
Volume control
This control allows you to balance the output from the subwoofer to the main speakers in your system. This control should be set to achieve similar volume level from both the main speakers and subwoofer.
Low-pass crossover
Both sets of inputs sum the left and right channels together and the resulting signal is passed through an adjustable
You should set the crossover frequency to obtain a smooth and seamless transition from the subwoofer to the main speakers in your system. If your
3☞
Placement
True subwoofers operate at extremely low frequencies which are primarily
Caution!
This subwoofer has electronics built into the cabinet. Do not place the cabinet next to sources of heat such as furnace registers, radiators, etc. Do not place the unit near sources of excessive moisture, such as evaporative coolers, humidifiers, etc. The power cord should be routed in such a way that it will not be walked on, pinched, or compressed in any way that could result in damaging the insulation or wire.
Care of Your DLS Subwoofer
Do not use any harsh detergents or chemicals to clean the cabinet. Abrasives, detergents, or cleaning solutions may damage the finish on the cabinet. We recommend using a damp cloth to clean the cabinet.
During normal conditions, the subwoofer may be left on continuously without any problems. The unit is equipped with a signal sensing circuit that will automatically turn on the unit when a signal is present at the inputs and turn off the unit after several minutes when there is no longer any signal at the inputs.
If you plan to leave the unit unused for an extended period of time, we recommend that you turn off the unit by the master power switch on the rear panel.
continued. . .
8☞