MEMORY OPERATION

STANDARD MEMORY OPERATION

The Standard Memory of the FT-2000allows storage and recall of up to 99 memories, each storing frequency, mode, and a wide variety of status information detailed previously. Memories may be grouped into as many as six Memory Groups, and additionally you get nine pairs of band-limit (PMS) memories along with five QMB (Quick Memory Bank) memories.

Memory Storage

1.Set the Main band (VFO-A) up with all frequency, mode, and status the way you want to have it stored.

2.Press the [A￿M] button momentarily (the current chan- nel number will start blinking in the multi-panel win- dow); the contents of the current memory channel will be shown on the Sub band (VFO-B) display field.

3.Rotate the [SUB VFO-B] knob to select the memory channel onto which you wish to store the data. If you have selected a channel on which data is already stored, that frequency will appear on the Sub band’s (VFO-B) frequency display field.

4.Press and hold in the [A￿M] button for two seconds to store the frequency and other data into the selected memory channel. A double beep will confirm that you have held the [A￿M] button in long enough.

[A￿M] Button

[SUB VFO-B] Knob

Memory Channel Recall

1.Press the [V/M] button, if necessary, to enter the Memory mode. A memory channel number will ap- pear in the multi-panel window.

2.Press the [M CH] button. The Red LED inside the but- ton will light up, indicating that you are ready to recall a memory channel.

ADVICE:

If the Red LED imbedded in the [M CH] button does not light up, check to be sure that the orange lamp to the right of the [SUB VFO-B] knob is not illuminated. If it is, press the [A/B] switch to make it go out, then press the [M CH] button again.

3.After pressing the [M CH] button, you may rotate the [M CH] knob to select the desired memory channel.

ADVICE:

To work within a particular Memory Group, press the [GRP] button (the imbedded LED will glow Red), then rotate the [SUB VFO-B] knob to select the desired Memory Group. Now press the [M CH] button (the im- bedded LED will glow Red); you may now choose the memory channel within the selected Memory Group.

[V/M] Button

[A/B] Button

[SUB VFO-B] Knob

[GRP] Button

[M CH] Button

Page 96

FT-2000 OPERATING MANUAL