Vertex Standard HX270E

HX270EPage 12

HX270E

Installing the Quick Draw Belt Clip

1. Connect the hanger to the rear of the HX270E, with the notch point-

ing directly up, using the supplied screw (Figure 6-a).

Use only the screw included

with the clip to mount the clip

to the back of the transceiver!

2. Clip the Quick Draw Belt Clip to

your belt (Figure 6-b).

3. To install the HX270E into the

Quick Draw Belt Clip, align the

hanger with the Quick Draw Belt

Clip and slide the HX270E into

its slot until a click is heard.

4. To remove the HX270E from the

Quick Draw Belt Clip, Rotate the

HX270E 180 degrees, then slide

the transceiver out from the Quick

Draw Belt Clip (Figure 6-c).

1. Install the belt clip on the transceiver, if desired.

2. Install the battery pack on the transceiver (see

figure 1 and section 3.2).

3. Install the antenna onto the transceiver.

NOTE

Water resistance of the transceiver is assured

only when the battery pack and antenna are

attached to the transceiver.

Figure 5

Antenna Installation

Figure 6

(a)

(b)

(c)

belt