9. Sequential Tone Deviation
This parameter is to align the “Sequential Tone Deviation” (for 2-Tone, 5-Tone and DTMF sequential tones).
1. Press the “Start” button to start the alignment.
2. Set the value to get desired deviation by changing the
slide bar on your PC.
3. Press the “OK” button after getting the desired value
to save the re-aligned value, the alignment of the SE-
QUENTIAL TONE DEVIATION is accomplished.
8. Sub Audio Deviation <CTCSS> / <DCS>
This parameter is to align the Deviation of Sub-Audio (CTCSS/DCS). The “TX VCO Tune Voltage” and “Max Deviation”
must be done before this alignment is started.
1. Press the “Start” button to start the alignment.
2. Set the value to get desired deviation (Wide: 0.6kHz)
on the deviation meter by changing the slide bar on
your PC.
3. Press the “OK” button after getting the desired value
to save the re-aligned value, the alignment of the MAX
DEVIATION is accomplished.
7. Maximum Deviation <Wide> / <Narrow>
This parameter is to align the Maximum Deviation (Wide/Narrow). The “TX VCO Tune Voltage” must be done before
this alignment is started.
1. Press the “Start” button to start the alignment.
2. Set the value to get desired deviation (Wide: 4.2kHz,
Narrow: 2.1kHz) on the deviation meter by changing
the slide bar on your PC.
3. Press the “OK” button after getting the desired Devia-
tion to save the re-aligned value, the alignment of the
MAX DEVIATION is accomplished.
Alignment