Vestax Mixing Controller owner manual Isolator Section, Rear Panel

ISOLATOR SECTION

25, HI SWITCH

Allows cutting off the sound of treble range. Sound volume will be cut when the switch is set downwards. When the switch is put back, the output volume returns to normal. Can be useful for cutting off the sound of the cymbals or high hats for example.

26, MID SWITCH

Allows cutting off the sound of the middle range. Sound volume will be cut when the switch is downward position. When the switch is put back, the output volume becomes normal sound volume. Can be used for cutting off vocal and melody from the source.

27, LOW SWITCH

Allows cutting off the sound of the bass range. Sound volume will be cut when the switch is set downward. When the switch is put back, the output volume return to normal. Can be utilized for creating the effects of an acapella.

ISOLATOR SECTION

PGM1 ISOLATOR

LOW MID HI

27 26 25

REAR PANEL

28		30		31
POWER		PMC-27						AC100V	50 / 60Hz 16W
						MADE IN JAPAN	SERIAL NO.
ON		OUTPUT	EFFECT		PGM 2		SUB	PGM 1
OFF	MASTER OUT 1		SEND	R	LINE 6	L		R	LINE 2	L
	R	L	R	L
						R	LINE 3	L

34

AC 100V

	LINE 5		LINE 1
R	L			33
MASTER OUT 2	PHONO 3	PHONO 2	PHONO 1
	RETURN
		GND	GND	35

29

32

REAR PANEL

28.POWER SWITCH

The first LED of MASTER OUT LEVEL METER that is located on the top panel is lit when on.

29.AC POWER CABLE

30.OUTPUT JACK(1/4inch PHONE JACK, RCA PIN JACK) Connect to the input of power amplifier.

31.EFFECT SEND JACK

Connect the SEND jacks to the input of an external effector unit(Delay,Reverb etc)

32.EFFECT RETURN JACK

Connect the RETURN jacks to the output of the effector.

33.PHONO INPUT JACK

Input jack for PGM1,PGM2 and SUB channel turntables.

Connect turntables equipped with the MM pick up certridge only.

34.LINE INPUT JACK

Input connectors for the line level equipment such as CD players, tape decks, DATs, MDs.

35, GROUND TERMINAL

Connect this terminal to the ground lead of the turntable. This helps to redusce noise and hum.