Vicks V3500 Using Your Vicks Natural Mist Humidifier, Operating Instructions, Care and Cleaning

Fill the Water Tank and replace Tank on Base.

Fill Base with undiluted white vinegar. Let solution stand for 20 minutes.

Turn switch to the OFF (O) position and unplug the cord from wall outlet.

Make sure the circular rubber Cap Gasket (O-Ring) is in place before replacing Fill Cap on Tank (this prevents water leakage). To tighten, turn Fill Cap clockwise.

Empty any remaining water from the Base and Tank. Reassemble Humidifier.

Completely unravel power cord. Inspect power cord for signs of damage before use. If cord is damaged, DO NOT use product, please call 1-800-477-0457.

Keep cord away from heated surfaces and out of the way, where it cannot be stepped on or tripped over.

Turn switch to off (O) position and unplug the cord from wall outlet.

Unpack Humidifier. Remove Fan Housing and check that the Wicking Filter is in place in Base. Replace Fan Housing, being careful to seat it properly onto the Base.

Using Your Vicks® Natural Mist Humidifier

Your Vicks Humidifier comes fully assembled and ready to use.

First Time Use

Read all instructions before using this appliance.

Filling the Humidifier

1.

2. Place Humidifier at least FIVE inches away from walls and heat sources, on a FIRM, FLAT, LEVEL surface. Place on a water-resistant, non-conducting surface for protection from inadvertent spillage. Do not place any object over the Humidifier; it could block air openings.

3.

4.

5. Remove Tank using Tank Handle. Turn Tank over and carefully remove Fill Cap by turning Fill Cap counter clockwise. Fill the Tank with cool tap water. WARNING: Never use hot water - may cause damage to Wicking Filter.

6.

7. When carrying Tank always use two hands (one on Handle, one on the Fill Cap). Insert Tank back into Base.

Operating Instructions

1.

2. Make sure that switch is in OFF (O) position, place the unit on a flat, stable surface and plug cord into a 120 VAC wall outlet.

CAUTION: DO NOT PLUG IN THE CORD WITH WET HANDS; ELECTRIC SHOCK COULD RESULT.

3. Turn switch to either High or Low. Fan will start turning.

Care and Cleaning

CAUTION: ALWAYS TURN OFF THE POWER SWITCH AND DISCONNECT THE POWER CORD FROM THE ELECTRICAL OUTLET BEFORE CLEANING.

Humidifiers provide comfort by adding moisture to dry indoor air. For maximized benefit from your Vicks Natural Mist Humidifier, follow instructions carefully. Please note that this is an electric appliance and requires careful attention when in use.

Tap water may contain pollutants and minerals (scale) that can deposit on the inner surfaces of the Humidifier and clog the Wicking Filter. Such scale can accelerate the growth of microorganisms and can impair the performance of the Filter.

Daily Maintenance

1.

2. Remove Tank & Fan Housing and empty Base. Rinse Base and Tank, wipe clean, and dry with a clean cloth or paper towel. Be careful that you do not damage the delicate Wicking Filter. DO NOT immerse the Fan Housing or clean with water.

3. Replace Fan Housing then the Tank. Humidifier is now ready for use.

Weekly Maintenance—Removing Scale

1.

2. Turn switch on and operate the Humidifier without water until the Wicking Filter is thoroughly dry.

3.

4. Remove Tank & Fan Housing and place on a flat surface. Remove the Wicking Filter from the Base by carefully lifting straight up, without bending or breaking or tearing the Filter.

5.

6. Dampen soft, clean cloth or sponge with undiluted white vinegar and wipe out Base to remove scale. DO NOT use soap, detergents or abrasive cleaners.

7. Rinse thoroughly in clean warm water to remove scale and vinegar before disinfecting the Base.

Disinfecting Base

1. Fill Base with 1 teaspoon of household bleach in 1 gallon of water. Let solution remain for 20 minutes, stirring every few minutes to ensure that all surfaces are coated.

2. Empty Base after 20 minutes. Rinse with water until bleach smell is gone. Dry with clean cloth or paper towel.

3. Wipe all exterior surfaces of the Fan Housing with a soft, dry cloth.

DO NOT USE WATER TO CLEAN THE FAN HOUSING. AN ELECTRIC SHOCK MAY RESULT OR THE HUMIDIFIER MAY BE DAMAGED. DO NOT IMMERSE OR SPRAY ANY PART OF THE HUMIDIFIER WITH WATER.

4. Replace the Wicking Filter into the Base, being careful not to damage the Filter. NOTE: Do not wash the Wicking Filter, since this will damage the Wicking Filter.