9
Installing the Base
Follow these steps to install the base:
1. Turn the monitor down.
2. Assembly the base to the arm with screw.
3. Tighten the screw with a coin.
Installing the Monitor
This monitor is equipped with an auto sensing DC power adapter for voltage
ranges of 100-240VAC, 60/50Hz. Follow these steps to install the monitor:
1. Before you connect the cables, made sure that the monitor and the system
unit power switches are off.
2. Plug one end of the 15 pin-signal cable to the monitor and the other end to
the video signal connector at the rear of the system. Tighten the two screws
on the cable connector.
3. Connect the AC/DC power cord to the DC jack.
4. Connect the power cable.
Micro-controller Features
The micro-controller automatically detects the video board installed in your
system. When you turn on the monitor, the micro-controller checks the
display mode memory stored in the user setting area of the video board, and
then the factory presetting area. It then adjusts to the proper display mode.
The micro-controller has the memory capacity t o store different display
modes, including timing formats and display-settings. This memory capacity
is divided into two parts: the user setting area and the factory presetting area.