Quick Installation

E

1 Connect video cable

Make sure both the monitor and computer are

N

powered OFF.

GConnect theDB-15 video cable to the

Lcomputer. (The monitor can also be

Iconnected to a BNC video cable, purchased separately).

SMacintosh® users: Models older than G3

Hrequire a Macintosh adapter. Attach the

adapter to the computer and plug the video cable into the adapter.

To order a ViewSonic® Macintosh adapter, contact ViewSonic. See “Customer Support” on page 14.

2Connect monitor base cord

Connect the monitor base cord from the AC OUT port to the AC IN port on the monitor.

3Connect power cord

Connect the power cord from the monitor base to a properly grounded AC outlet.

4Connect USB devices

Connect the USB cable from your computer USB port to the USB Input on the rear of the monitor base. To use the USB Hub, connect the selected USB devices (up to four) to the USB downstream ports shown below.

5Power-ON monitor and computer

Power-ON the monitor, then power-ON the computer. This sequence (monitor before computer) is very important.

NOTE: At this point Windows 98 users may receive a message asking them to install the P225 INF file.

Monitor base cord

USB ports

Monitor power cord

6Install Display Optimization files (INF and ICM files)

(1) Insert the ViewSonic Wizard CD-ROM into your computer’s CD-ROM drive.

NOTE: If your computer does not have a CD-ROM drive, see “Customer Support” on page 12.

(2) Wait for the CD-ROM to auto-start.

NOTE: If the CD-ROM does not auto-start: double-click on the CD-ROM icon in Windows Explorer, then double-click on install.exe.

(3) Follow the on-screen instructions.

7Windows users: Set the Timing

Mode (resolution and refresh rate) Example: 1024 X 768 @ 75Hz.

For instructions on changing the resolution and refresh rate, see the user guide for your computer's graphics card.

Installation is complete.

Installation is complete. Enjoy your new P225 monitor.

To be best prepared for any future customer service needs: print this user guide and write the serial number in "For Your Records" on page 1. (See back of monitor.)

To register your product go online to www.viewsonic.com.

The ViewSonic Wizard CD-ROM also provides an opportunity for you to print the registration form which you may mail or fax to ViewSonic.

Power cord

Video cable

USB cable

4 ViewSonic P225