When you enter this control, the screen below will be displayed.
The factory default of the password is “0000”.
To enable parental control, input the password, press ▼ button to focus on “ok” key, and press ENTER. (select Cancel if you want to exit)
After entering, the following screen will be shown.
Channel Lock: To lock channels. Use ◄► to select the channel you want to lock, and then press ENTER to lock or unlock it.
Change Password: To change the password, press ENTER and enter the password again. Press ENTER, and the following screen appears.
Enter the new password, use ▼ to move the cursor down, and then enter the new password again, press OK to confirm or Cancel to exit.
Note: Please make sure you remember your new password after changing, because you cannot recall the default setting of the password by any selection.
Clear All: To clear all the locks set before, press ENTER.
Press MENU to return to the previous page.
•Color Temperature: To select the color temperature from Warm, Cold, Normal or User. (If you select User, you can adjust the degree of R, G, B in Color Temp. to suit your personal preference.)
•Back Light: To adjust the luminance of the back light.
•Aspect Ratio: To select image size between Normal, Full, Wide1, Wide2, Wide3, 4:3, 16:9, and No scale.
•OSD Timeout: To setup the display time of OSD. (5, 15, 45, and 60 seconds)
•Memory Recall: To restore the factory default settings.
ENGLISH
ViewSonic | 20 | N3252w |
