ViewSonic Z50 Quick Installation

	E	1 Connect video cable
	N
		Make sure both the monitor and computer
	G
		are powered OFF.

LConnect the video cable to the computer.

IMacintosh users: Models older than G3

Srequire a Macintosh adapter. Attach the

Hadapter to the computer and plug the video cable into the adapter.

To order a Macintosh adapter, contact ViewSonic®. See “Customer Support” on page 12.

2 Connect power cord

Connect the power cord from the monitor to a properly grounded AC outlet.

3 Power-ON monitor and computer

Power-ON the monitor, then power-ON the computer. This sequence (monitor before computer) is very important.

NOTE: At this point Windows 98 users may receive a message asking them to install the Z50 INF file.

4 Install INF and ICM files

For CD-ROM: Insert your CD-ROM, select “Monitor Drivers,” and follow the on-screen instructions.

For diskette: Insert your diskette and run install.exe. Follow the on-screen instructions.

5 Windows users: Set the Timing

Mode (resolution and refresh rate)

Example: 800 X 600 @ 75Hz.

For instructions on changing the resolution and refresh rate, see the user guide for your computer's graphics card.

Installation is complete. Enjoy your new Z50 monitor!

To be best prepared for any future customer service needs:

Write the serial number (see back of the monitor) in “For your Records” on page 2 of this guide.

www.viewsonic.com

Video Cable

AC Outlet

Power Cords

Optiquest

Z50