HOW TO CLEAN THE DRAIN PUMP | Pump wing | |
You can reach the drain pump from the inside of | ||
| ||
the machine. First remove the coarse strainer and |
| |
the horizontal filter. Then, remove the small cover |
| |
in the bottom left of the hole. There you can |
| |
reach the pump wing and remove the dirt. |
| |
Replace the cover, strainer and fine filter. |
|
HOW TO CLEAN THE DOOR
To clean the edge of the door, use only a soft damp cloth. Do not use any type of spray cleaner.
WINTER STORING IN UNHEATED PLACES
If the dishwasher is kept in a place that is not heated, the draining and circulation as well as the inlet valve must be emptied of water. For further information, contact your dealer. Freezin9 ruptures are not covered by warranty.
TROU IBILIESHOOTIING
A simple fault may prevent the dishwasher from working, You may be able to remedy this yourself, Trace the fault with the help of the points listed below, Also, be sure to read "Poor Dishwashing Results" for more problems, possible causes, and suggested remedies,
THERE IS WATER LEFT IN DISHWASHER
If the dishwasher is taking in too much water, the drainage pump starts automatically. If the water, in spite of this, is not drained off, it might depend on any of the following reasons:
THE FILTER IS CLOGGED: Lift out the coarse strainer and empty it. Place back in dishwasher before starting.
THE PUMP IS BLOCKED: Pieces of bone or other foreign particles might be stuck in the drainage pump. (See "How to Clean the Drain Pump").
THE DRAIN HOSE IS CLOGGED (BLOCKED):
Check to make sure that there are not obstacles in the hose
where it connects to the water. Foreign particles can get stuck in the entrance of the connection line. Also, check to
make sure that the
THE DRAIN HOSE IS KINKED:
Check to make sure that there are no folds or sharp bends in the drain hose.
AIR GAP: If the machine is equipped with an air gap, see page 11. Be sure the air gap is not blocked or plugged.
THE DISHWASHER DOES NOT START:
•Make sure the dishwasher is turned on and the door is closed securely.
•Make sure the DELAY option is not turned on.
• Check | that the water supply is connected properly and the water is | Hose |
| ||
turned | on. |
|
•Make sure the power cord is properly plugged into the wall socket.
•Check your fuse box for a blown fuse or tripped circuit breaker.
12
