NOTE: Drawer may be removed to facilitate the cleaning surrounding areas.

1.Disconnect power supply to compactor before removing drawer.

2.Be sure ram is in “up” position.

3.Open drawer to fully extended position.

4.Remove any drawer retaining screws which hold drawer to track assembly. Carefully remove drawer from track assembly, making sure that the full weight of the drawer is supported at all times.

COMPACTOR EXTERIOR

Front Panels:

Wipe clean with a cloth or sponge and mild detergent and water. Rinse with clear water and wipe dry. Do not use abrasive cleaners. ON stainless steel models, use a stainless steel cleaner and polish.

USE ENERGY WISELY

A trash compactor uses a negligible amount of energy. Total energy requirements associated with the trash compactor will be minimized by following the recommendations in the Use and Care Guide.

Service Information

It is assumed that your trash compactor has been properly installed in accordance with all specifications and local codes and that the appliance has been properly grounded. If your trash compactor should fail to operate, check the troubleshooting guide before calling your dealer. You could save the cost of a service call.

If your trash compactor should fail to operate:

-Have you read and followed the instructions provided with this unit? -Is a fuse blown or the circuit breaker open?

-Is the trash drawer tightly closed? It is possible for a cycle to be incomplete when the drawer has not been firmly closed before turning the key to START. If this occurs, the unit will shut-off, but the drawer cannot be pulled open. Close the drawer firmly and turn the key to START. The ram will return to the original “up” position. Drawer will open only when ram is all the way up.

-Compacting works best when only a few items are loaded. Use the compacting cycle frequently.

-Not all bottles will break every time, depending upon trash load below.

14

If compactor stops during operation:

-Push drawer in while turning key to start. Repeat if necessary.

-Rearrange trash load. Do not load rigid items in front of drawer. -Drawer must be at least 1/3 full to see compaction.

If Service is Required:

1.Call your dealer or authorized service agency. The name of the authorized service agency can be obtained from the dealer or distributor in your area.

2.Have the following information available: -Model number

-Serial number

-Date purchased

-Name of dealer from whom you purchased the appliance.

3.Clearly describe the problem you are experiencing.

If you are unable to obtain the name of an authorized service agency, or continue to have service problems, call Viking Range Corporation,

(662) 451-4133, or write to:

Viking Range Corporation

Preferred Service

111 Front Street

Greenwood, Mississippi (MS) 38930 USA

Record the information indicated below. You will need it if service is ever required. The serial and model numbers for your oven are located on an identification plate mounted on the bottom left side of the oven door opening.

Model Number

 

 

 

Serial Number

 

Date Purchased

 

 

Date Installed

 

 

Dealer’s Name

 

 

 

 

 

Address

 

 

 

 

 

 

 

 

 

 

If service requires installation of parts, use only authorized parts to ensure protection under the warranty.

This manual should remain with the oven for future reference.

15

Page 8
Image 8
Viking F1213F Service Information, If your trash compactor should fail to operate, If compactor stops during operation

F1213F specifications

The Viking F1213F is a remarkable amphibious aircraft that has garnered attention for its versatility and performance in various operational environments. Designed for a plethora of missions, the F1213F combines state-of-the-art technologies with a robust design, making it an ideal choice for both commercial and governmental use.

One of the standout features of the F1213F is its ability to operate on both land and water, a characteristic that significantly expands its operational capabilities. This amphibious design is powered by a modern turboprop engine that provides an efficient and reliable performance across a range of altitudes and speeds. The aircraft boasts a cruising speed of approximately 200 knots and a maximum range of around 1,200 nautical miles, making it suitable for long-distance missions.

The F1213F showcases advanced avionics and navigation systems that enhance pilot situational awareness and operational efficiency. These systems include a digital glass cockpit, multi-functional displays, and advanced weather radar, which collectively contribute to safer and more effective flight operations in diverse weather conditions. Additionally, the aircraft is equipped with a fully integrated autopilot, reducing pilot workload during extended flights.

In terms of payload capacity, the F1213F is designed to accommodate several configurations. It can transport up to 1,500 kg of cargo or a maximum of 12 passengers, making it particularly attractive for search and rescue missions, medical evacuations, and business travel. Its spacious cabin can be reconfigured quickly, allowing operators to adapt to various mission requirements.

The Viking F1213F also places a strong emphasis on safety and durability. Constructed using lightweight composite materials alongside traditional aluminum, the aircraft is designed to withstand the rigors of both water and air operations. The hull design minimizes drag during water takeoffs and landings, while also ensuring stability in challenging maritime conditions.

Overall, the Viking F1213F is an impressive amphibious aircraft that exemplifies innovation in aviation technology. Its combination of versatility, advanced systems, and robust design make it a valuable asset for operators seeking a reliable platform for a wide range of missions. Whether for business, emergency response, or recreational flying, the F1213F stands out as an excellent choice in the growing field of amphibious aviation.