Viking F20288 specifications Replacing the battery built-in models, Service Information

Replacing the battery (built-in models)

Each built-in oven is equipped with a battery for the electronic ignition.

To replace the battery:

1.Locate the lower access panel on the front of the oven.

2.Remove the two screws located at the top of the access panel.

3.Locate the round black cap behind the access panel.

4.Unscrew cap. Battery is snapped in the cap.

6. Snap cap on battery and screw back into slot inside the oven.

9-volt battery

Battery cap

Screws holding access

panel

Lower access panel

Service Information

If unit fails to operate:

1.Replace battery

2.Call for Service

If service is required:

1.Call your dealer or authorized service agency. The name of the authorized service agency can be obtained from the dealer or distributor in your area.

2.Have the following information readily available: Model Number

Serial Number Date of Purchase

Name of dealer from whom purchased

3.Clearly describe the problem that you are having.

If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking Range Corporation at (888) 845-4641 or write to:

VIKING PREFERRED SERVICE

111 Front Street

Greenwood, Mississippi 38930 USA

Record the following information indicated below. You will need it if service is ever required. The serial number and model number for your oven is located behind the lower access panel.

Model Number	Serial Number
Date of Purchase	Date Installed
Dealer’s Name
Address

Please retain the manual for future reference

14 15