54

Installation - Side Panel, Top Panel and Grille(Wrapped Installation)
Required Components Remove and discard screw and hinge cover,if
applicable. (Repeat if two hinges are used.)

1

Left Panel Right Panel
TopPanel
Front Grille
Caps
AB
Screws
C
Remove edge of corner cover.

2

A
A- Designer Series
B- Pro Series

3

Withtop panel andgrille upsidedown, positiongrille
assemblyin frontof top panel.Secure toppanel to grille
assemblyviafour outer holesand three innerholes.
Remove adhesive backing from the side panel. Fit the
side panel to the front of the unit first.
2
1

4

Attach rear of side panels with screws.
NOTE: The holes on the side panel are clearance holes.

5

Installation - Side Trim and Grille(Built-In Installation) (cont.)

6

B
Secure the grille brackets to the holes in the hinge
plate with two B screws.

7

72”

Raise the unit up until the measurement from the floor
to the top of the grille assembly is 72 inches or 6 feet.

8

2
2
1

9

2
2
1

complete

Shim trim has adhesive backing on both sides. Remove adhesive
backing on refrigeratorside only. Fit the shim trim to the front of the
unit first. Locate the top of the shim trim with the top of the
refrigerator cabinet.
Remove adhesive backing for the side trim. Locate the
top of the side trim with the top of the grille assembly.
Press the side trim into the refrigerator cabinet at the
center location.