Viking VDB325 manual Undercounter 24W. Dishwasher Installation Requirements, 37 max

UTILITY

REQUIREMENTS

GAS

Not applicable

ELECTRICAL

•6’ (1.8 m), two-wire cord with grounded, three-prong plug supplied with unit

•120 VAC/60 Hz

•Maximum amp usage—15.0

•Water-heating element rating—1,200 watts

PLUMBING

KITCHEN CLEANUP

Undercounter 24”W. Dishwasher

Installation Requirements

ACCESS REQUIREMENTS

DFUD042P/142P	DFUD042D/142D	DFUD042/142
Professional	Designer	Custom Front
		See Custom Panels section for
		more information and additional
		specifications.

•120°F (49°C) hot water recommended; dishwasher will, however, perform properly with cold water (Cycle times will vary)

•Inlet water pressure operating range—18

– 176 psi (125 – 1,227 kPa)

•6-1/2’ (2.0 m) 3/4”

(1.9 cm) ID “crimp- proof” rubber drain hose with clamp attached to dishwasher; can be extended up to a maximum of 10’ (3.0 m) with 3/4” (1.9 cm) ID copper tubing

•High loop of drain hose required; min. height from floor— 24” (61.0 cm); max. height—35” (88.9 cm)

•6’ (1.8 m) PEX water line with 3/8” (0.95 cm) compression fitting (NPT female connection) supplied with unit

•Check local codes for drain air gap requirement

24”	24”*
(61.0 cm)
	(61.0	cm)

34-
1/4”		min.
(87.0
	cm)
37” max.
(94.0	cm)

Note: A 1-1/2” cutout is required for water supply and discharge lines.

*When installing the dishwasher without the side trim, the cutout must be 23-5/8” (60.0 cm), and approximately 4” (10.2 cm) of the inside cabinets must be finished.

		All models
Cutout width		24” (61.0 cm)
Cutout height	34-1/4” (87.0 cm) min. to 37” (94.0 cm) max.
Cutout depth		24” (61.0 cm)
P L A N N I N G A N D D E S I G N G U I D E		R E L E A S E D 1 2 / 1 / 0 7
V I K I N G R A N G E . C O M	• 1 - 8 8 8 - V I K I N G 1	© 2 0 0 7 V R C — INFORMATION SUBJECT TO CHANGE