Function introduction
Remote Controls
1 | OPEN/CLOSE Button | |
2 | 6 | |
3 |
| |
| 7 | |
4 | 8 | |
5 | BACK/NEXT Button | |
REPEAT Button | ||
PLAY/PAUSE Button | 9 | |
STOP Button | ||
| ||
| 10 |
Incept Windows
Remote Control
When Operating the remote control, point it at the remote sensor located on the amplifier is front panel.
The remote control can be used up to 7 m from the amplifier and within a 30 angle on each side of the sensor.
Notes : Exposing the remote sensor to direct sunlight or strong light may cause faulty operation.
1. REMAIN Button
Switches the time shown on the display to the remaining time of the current track ( REMAIN )or the remaining time of the entire disc ( TOTAL REMAIN).
2.DIMMER Button
Press to adjust the display illumination brightness. the illumination is at its brightest when the power is switched ON. Each time this button is pressed, the brightness dim until the fourth press, after which the illumination returns the original brightness.
3.Numeric Button(0~10,10+)
These buttons are used to designate the track ( tune ) numbers for programming playback or " direct access " play.
4.REPEAT A-B Button
Usud to activate repeat play of the section between two designated poing ( block repat play).
5.INTRO A-B Button
When this button is pressed , the player automatically plays the first part of each track in the disc for 10 seconds.
6
